UKIAH / CSMI Thin Kerf Gang - 1990 model 6” x 24” guided bottom arbor, climb cut gang with positioning type infeed table, tunnel type outfeed conveyor, 350 HP motor, operator’s console and guides for 5/4 (1.20”) & 7/4 (1.72”) lumber. Gang features 4 powered knurled & chromed top rolls with pneumatic press cylinders, 7 knurled and chromed bottom feed rolls, splined arbor, and a clam shell opening for guide access. No guide lube system, no blades and no starters. Serial # 8068. This machine was recently removed from service to be replaced with a curve sawing system. It was operating on yellow pine at a feed rate of 140 feet per minute with a kerf of 0.130”. It is a climb cut blade rotation (toward the rear of the machine) so trash and debris fall toward back side of blades, away from the guides. Item # 12206.